Netgate XG-7100-DT No Response Issue
-
What settings are you using in putty though? What do you actually see?
-
I was using the default 9600 speed, I just adjusted it to 115200 and was able to connect to it via serial!
Thank you for pointing me in the direction of the Putty settings.
When I boot into it I keep seeing this error message: "pid 742 (php-cgi), uid 0; exited on signal 11 (core dumped) Segmentation fault (core dumped).
I assume I'll just have to wipe the config and start from scratch if that's any indicator that there is corruption going on.
Patrick
-
I would reinstall 23.05.1 clean and restore your config now you have access to the serial console. It's almost certainly the quickest way to get back up and running.
-
Got it! Thank you very much, I will proceed with that right now!
Thanks again for all the help!
Patrick
-
@pdowd0001 said in Netgate XG-7100-DT No Response Issue:
default 9600 speed
For next time... :)
https://docs.netgate.com/pfsense/en/latest/solutions/xg-7100/connect-to-console.html#putty-in-windows -
Thank you for that link!! I will save that for next time!
I was just going to type you a message, When I hit option 4 in the console to factory reset the device I get random PID error messages and it returns me back to the console page.
Is there a manual console command to initiate a factory reset?
Patrick
-
@pdowd0001 Resetting the configuration does not reinstall (a common misconception). It just restores a default config.xml file.
You can restore a config file from the console via option 15:
https://docs.netgate.com/pfsense/en/latest/backup/restore.html#console-configuration-history -
You can manually copy a default config in but that won't solve whatever php issue you have there. It only defaults the config.
I would still clean install the 23.05.1 firmware to be sure.
Open a ticket with us to get the image if you have not already: https://www.netgate.com/tac-support-request
-
-
Hi Steve,
Thanks again! I quickly got the firmware from support!
I was able to reinstall it to the appliance and am back up and running!
Thanks,
Patrick
