I can´t upgrade from 2.5.2 to 2.7.0
-
You can install the latest version and run the backup with another older version without affecting the base version
-
if i tried to update from consola, i have this messages. is a new installation on a virtual machine to test.
-
@fealiaga said in I can´t upgrade from 2.5.2 to 2.7.0:
You can install the latest version and run the backup with another older version without affecting the base version
Yes, you can restore a config from 2.5.2 (or any older version) into 2.7.
-
there is any form to upgrade from 2.5.2 to 2.7 manually
-
Upgrade to 2.6 first. Set the repo to 2.5.2. Then run:
pkg-static clean -ay; pkg-static install -fy pkg pfSense-repo pfSense-upgradeThen set tjhe repo to 2.6 and upgrade to that.
-
@stephenw10
I tried the way you told me, and it worked without problems, but I need to know how to update from 2.5.2 to 2.7 directly without having to use a new installation -
You have to go through 2.6. Use the instructions above to upgrade to that if you have tried to upgrade to 2.7 and failed.
-
i do the commands
then i tried to upgrade from the web but the web don´t do anything
also i tried from console and nothing
-
You didn't set the repo branch to 2.5.2 first. So it just reinstalled the 2.7 pkgs.
-
@stephenw10 so sorry i am new with this system, how i can set the repo to 2.5.2?
-
In System > Updates > Update Settings
-
@stephenw10 i only have this
-
Ok, try using 2.6 directly then. That should still allow you to upgrade from 2.5.2
-
@stephenw10 today works
upgrade to 2.6, now i have to try with 2.7 -
-
Looks good. Good luck!
Make sure you have a config backup and a recovery plan if you need it.
-
Hi! @stephenw10 how are you today? I tried to update my main pfsense server, which is installed on a Dell PowerEdge R6525 server, with three interfaces connected, one for the LAN, another for the WAN and one in trunk mode for all the interfaces of my company, and I had the following error message when trying to go from version 2.6 to version 2.7
"hwrm_cfa_l2_filter_alloc command returned invalid params error"
what i can do with this?Going from version 2.5.2 to version 2.6 there was no problem but now I have the problem with this latest update.
-
It's an error from the updated bnxt driver. Is the NIC still functioning as expected?
That's not an upgrade problem though, you should probably start a new thread for that.
-
@stephenw10 no, the interface did not work as needed, i will open a new thread
-
Probably this: https://redmine.pfsense.org/issues/14569
Or rather this: https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=269133
