ISP Delegates /64 Multiple Times But No /56 or /60

Bob.Dig

@vader9000 said in ISP Delegates /64 Multiple Times But No /56 or /60:

I can get ipv6 on my LAN and everything works fine ir passes all the test sites all green

You can try, it depends on your Modem/Router and ISP and so on. So what have you done so far to your pfSense config that it is working for your pfSense LAN?

vader9000

@Bob-Dig Thank you for replying.

Yes on the lan side everything is working fine and it passes all the ipv6 test sites.
the clients connected to the lan get the right ips ipv4 and ipv6 but as soon as i try to set up another interface it doesn't work or it works on the new interface and stops working on the LAN

so on the LAN i get a 2001:XXXX:XXXX:XXX1:aaaa:aaaa:aaaa:aaaa and clients get 2001:XXXX:XXXX:XXX1:aaaa:aaaa:aaaa:aaa1 & 2001:XXXX:XXXX:XXX1:aaaa:aaaa:aaaa:aaa2 & 2001:XXXX:XXXX:XXX1:aaaa:aaaa:aaaa:aaa3 which is how it shoud be.

and i still can connect 3 routers to the isp router and duplicate the results with the diferen /64 prefix 2001:XXXX:XXXX:XXX2:aaaa:aaaa:aaaa:aaaa & 2001:XXXX:XXXX:XXX3:aaaa:aaaa:aaaa:aaaa

IN The LAN
I HAve Tried with TRACK Interface WAN with and without DHCP6 and depending when i try with or without RA unmanaged / Assisted / managed no matter what i try wen i set any other interface this stops working or the other doesnt work

my question is : can i make the isp router detect my internal interfaces like its detecting the router i connect directly to the other isp router ports?

thanks

vader9000

@Bob-Dig
Don know if helps or not but ..

Router IS - HUAWEI OptiXstar HG8247X6-8N

NO BRIDGE MODE is available for residential contacts and NO STATIC IP

Bob.Dig

@vader9000 said in ISP Delegates /64 Multiple Times But No /56 or /60:

IN The LAN
I HAve Tried with TRACK Interface WAN with and without DHCP6 and depending when i try with or without RA unmanaged / Assisted / managed

What is the "DHCPv6 Prefix Delegation size" in your WAN-settings?

vader9000

@Bob-Dig

The only one it works is /64
wen i go /63 / 62 /60 /56 it doesn't work

Bob.Dig

@vader9000 said in ISP Delegates /64 Multiple Times But No /56 or /60:

The only one it works is /64
wen i go /63 / 62 /60 /56 it doesn't work

Then your out of luck I think.

vader9000

@Bob-Dig

Thank You

I was hoping that maybe could be possible to make the requests coming from the other interfaces look like different devices ... maybe vlans on the wan side ... i don't know that's beyond my abilities.

Thanks just the same
FC

Bob.Dig

@vader9000 Now what you can do is trying NAT with NPt. This will work ok with outbound connections but only partially with unsolicited inbound connections.

vader9000

@Bob-Dig

Can you please explain how i can do that on the pfsense so i can give it a try.

thks

Bob.Dig

@vader9000 Check the docs.
You have to roll out ULAs on all other Interfaces but the LAN, which still gets the one /64 that is working for you.

One example:

You have to create these rules for every other interface than LAN and change the Source accordingly.

vader9000

@Bob-Dig

Thank You Im Going to Try it

vader9000

@Bob-Dig

On The Interface Lets call it TEST(igb1.5) VLAN tag 5 i Set the interface as STATIC IPV6?
If so wen the ISP changes the ips for the router this will stop working correct?

Bob.Dig

@vader9000 said in ISP Delegates /64 Multiple Times But No /56 or /60:

On The Interface Lets call it TEST(igb1.5) VLAN tag 5 i Set the interface as STATIC IPV6?

Yes and you give it an ULA with /64 like shown above.

If so wen the ISP changes the ips for the router this will stop working correct?

No, LAN is still handled via Track Interface so in general it should work.

JKnott

@Bob-Dig said in ISP Delegates /64 Multiple Times But No /56 or /60:

You have to roll out ULAs on all other Interfaces but the LAN, which still gets the one /64 that is working for you.

Actually, you can add ULA to the LAN, along with GUA. In fact, I don't think ULA is allowed to route to GUA addresses.

Using Unique Local Addresses

vader9000

@Bob-Dig

Hello,

Thank you for the help, I managed to get it working on my test box so I will be setting up my live box.

Best regards,
FC

Bob.Dig

@JKnott said in ISP Delegates /64 Multiple Times But No /56 or /60:

Actually, you can add ULA to the LAN, along with GUA.

True but at least with Track Interface you need a patch for pfsense and this patch is only working partially.

In fact, I don't think ULA is allowed to route to GUA addresses.

Someone has to test this. I ditched my ULAs because of the mentioned problems, so it won't be me.

JKnott

@Bob-Dig said in ISP Delegates /64 Multiple Times But No /56 or /60:

Someone has to test this.

RFC 6724 describes priority when you have multiple addresses to choose from, but doesn't appear to get into the GUA <> ULA situation. However, I seem to recall reading elsewhere that it wasn't allowed. Can't say for certain though.

Anyway, I have both GUA and ULA on my subnets.

JKnott

@Bob-Dig said in ISP Delegates /64 Multiple Times But No /56 or /60:

Someone has to test this.

I just did and I can reach ULA from GUA. I tested from my VPN, which only has GUA to my desktop computer and it's ULA address.