WRAP: 1 eth for dual wan
-
Hello,
i have a WRAP board with 2 lan interfaces. one for wan and one for lan.
now i want to connect TWO internet lines (static ip - same subnet) to the ONE wan (ok using a switch to get the two ports) port and make load balanching. is this possible and when yes who to setup? i can change the ip from the ISP if necesarry.picture:
ISP1 - 10.10.10.1 – 1 WAN from WRAP -- LAN WRAP -- 192.168.X.Y
ISP2 - 10.10.10.2 --Martin
-
no one a solution for this problem?
when one line is fall back is there any possibility to change the gateway in the WRAP with a sh script when it recognized with ping that one ISp is down?
Martin
-
http://www.pfsense.org/mirror.php?section=tutorials/policybased_multiwan/policybased_multiwan.pdf
-
Hello,
the problem is the default gateway in the rule. i can only set it to default. but for some rules i have to set them to gateway1 and for others to gateway2.
i only have one wan interface !Martin
-
Not sure this will work. You'll need to breakup the 2 subnets on 2 interfaces.
I've seen reports of tricks flying around in the forum but I cannot speak for them so you'll need to do some searches for more information.
-
depending on what you have on the wan side.
you could have two vlans tagged to the wan interface.then just tag your switch on a port for each vlan and add a port for each of your wan connections.
as scott said use two differnet subnets