Upload traffic not shaped
-
OK
May be this resolved problem :-\ -
Yes.
-
Not resolved :'(
Any ideas?
This msg from System log->Firewall for send my mail (SMTP=25 port)
pf: 060440 rule 286.qmailDown.2/0(match): pass in on rl0: (tos 0x0, ttl 128, id 34703, offset 0, flags [DF], proto: TCP (6), length: 48) 10.62.0.21.4881 > 213.247.196.18.25: S, cksum 0x0de1 (correct), 2977173570:2977173570(0) win 64512 <mss 1460,nop,nop,sackok="">Rule take outgouing SMTP packet But not place them to queue - work only default queue</mss>
-
Post a screen shot of your traffic shapers rules section that includes the SMTP item.
Make sure you actually told it to prioritize SMTP on the others wizard screen.
-
OK, but only tomorrow.
Thxps in firewall log present only rl0 - Lan interface messages
-
It takes 1 minute total to take a screenshot.
Not sure what my schedule is tomorrow so it would be much better to post a screenshot.
Again, it only takes a mintue.
-
My shape rules
-
Only the default traffic shaper wizard configuration is supported right now.
Please rerun the traffic shaper wizard and test again without modifying anything.
-
Only the default traffic shaper wizard configuration is supported right now.
Please rerun the traffic shaper wizard and test again without modifying anything.
Nothing…
this my "worked" config - shaped only incoming
and ./tmp rulez set
file 2.exe.txt rename to 2.exe and run to unpack (rar archive)pls look this - may be resolve problem
ps wan interface shaped only for default rule - t.e. wan interface support altq
-
-
No offense but I am not running an executable from someone that I do not know.
Please post in a non virus ridden format.
-
No offense but I am not running an executable from someone that I do not know.
Please post in a non virus ridden format.
rules.txt
qlanacks.txt
qlandef.txt
qlanRoot.txt
qmailDown.txt
qmailUp.txt
qOthersDownH.txt
qOthersDownL.txt
qOthersUpH.txt
qOthersUpL.txt
qwanacks.txt
qwandef.txt
qwanRoot.txt
qwebDown.txt
qwebUp.txt -
Bridging interfaces + shaping does not work in 1.0.
-
:-\
Ofiget.
Bridging interface can shape in theory?
Exist any other project where this worked?
I'm in bad situation :-[ -
It can shape in theory but our code does not handle it. We had enough trouble getting to where we are now.
Patches accepted.
-
OK
-
m0n0wall can shape in bridging situations. enable filtering bridge at system>advanced and set up pipes, queues and rules. m0n0's shaper is completely different though but it can shape in a bridgescenario.
-
Bridging interfaces + shaping does not work in 1.0.
I have no Bridging interfaces, but outgoing traffic shaping does not work. RC3.
-
Works fine here.
Did you reset states after running the shaping wizard?
-
Works fine here.
Did you reset states after running the shaping wizard?
Yes. I did it many times :( Queues made by shaper wizard works only - qwandef & qwanacks