Installer doesn't see drives

sbn · Nov 30, 2005, 3:07 AM

Just downloaded 0.95a.iso and 0.95ab.iso. I selected install to hard drive, install GUI comes up fine. But, it will not install as the installer does not see any drive. Upon boot though I do see the IDE drive identified. I swapped out drives and came up with the same issue. The drives are just standard ATA on a P-II (Compaq) desktop w/2 NICs and no other cards installed etc.. System has 512MB RAM, 2 3COM 905C cards.

I previously had installed 0.94.10 on the same machine on another drive that was pulled out for use in another machine. It is when I went to re-install PFsense I decided to see about installing a newer ver.

sullrich · Nov 30, 2005, 5:40 AM

Fixed in 0.95.c