ALIX board
-
I have an Alix board but I keep getting
ath0: ath_chan_set: unable to reset channel 8 (2447 MHz, flags 0x480), hal status 3
Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0xe
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc0616d9a
stack pointer = 0x28:0xc27e1ba8
frame pointer = 0x28:0xc27e1c0c
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 12 (swi4: clock)
trap number = 12
panic: page fault
cpuid = 0
Uptime: 1m35s
Cannot dump. Device not defined or unavailable.
Automatic reboot in 15 seconds - press a key on the console to abortThis happens every time I try to active the wireless. The wireless chip is a AR9220 I have tried both 18/01/11 and 31/12/10 buids but both do the same.
-
Can you load the newly created developer on the board and try to get a panic. Installation instructions are at the end of http://forum.pfsense.org/index.php/topic,31721.45.html.
Not sure if it works on nano, but I do know it works on full. -
I am also getting
ath0: ath_chan_set: unable to reset channel
ath0: ath_reset: unable to reset hardware; hal status 3
So this maybe a hardware or driver issue.
-
That is a firmware issue.
Possibly a new firmware might be needed but i cannot have the card to test. -
So are there drivers for the Atheros AR9220? Sorry but I wasn't able to confirm this from searches as the posts were over 1 year old.
-
Any idea's
-
Same here:
ath0: unable to reset hardware; hal status 3
ath0: ath_chan_set: unable to reset channel 13 (2472 MHz, flags 0xa0), hal status 3
ath0: ath_chan_set: unable to reset channel 2 (2417 MHz, flags 0xa0), hal status 3
and so on…Seems somebody tries to fix it (10. March 2011):
http://groups.google.com/group/mailing.freebsd.mobile/browse_thread/thread/108658f53a476879?pli=1