2 wan ip only 1 gateway no work after update
-
You do not need opt1 for second wan ip. Both are on same subnet.
Just Create an Ip alias at wan interface and it will work.
-
i can use alias but the rules and nat over firewall work in ip of alias? i need separe rules
-
i can use alias but the rules and nat over firewall work in ip of alias? i need separe rules
Set outbound nat to manual and set your rules.
Use same network on two interfaces is not correct unless you are using bridge.
-
the rules are inbound and in the GUI in interface WAN i cant see alias for the interface wan
-
Alias are in 'virtual ip' gui tab.
-
I were using four external interfaces during 1.2.3 with the same gateway since this allows me to get 4 times the upload from my provider.
Now with 2.0 it won't work as stated before. Is the stated solution usable on my setup as well.
I'm using DCHP on my WAN-ports and are trying to loadbalance outbound between them. -
alias in virtual ip work for me
work for statick ips in dhcp mode i dont know -
alias in virtual ip work for me
work for statick ips in dhcp mode i dont knowThat was the question since I can't find any virtual dynamic IP.
-
Multiple dhcp clients on same net sounds completely unusual and routing confusing to me.
-
Reason is stated earlier but I'll explain further…
I have a LAN provider who gives me 100Mbps download but only 10Mbps upload. They provide me with five IP-addresses through DHCP and each of the IPs each get 10Mbps of upload. Since they give me IP-addresses from a /16 net I get the same gateway on all IPs. This means if I put a firewall with five WAN-addresses and load-balance them I get 50Mbps upload. It works with 1.2.3, not flawless but it works, and I have also used Shorewall to do this job and am now asking you if I can do this with pfsense 2.0?
I'm currently trying to provide enough bandwidth to host a couple of game servers and really need the extra 30-40Mbps I'm trying to get here.
Sorry if I don't make any sense...
