Limiter not working
-
these are screenshots
-
1/ Need to see the entire ruleset for that interface (or at least any rules before this one)
2/ The goal here is? I don't think you want mask "None" if that's supposed to be a per host limit. -
there's no other rules, this is the default one on LAN
And another rule for port forwarding on WAN (ftp server)I need to put limits on certain hosts, and I followed the instructions to set the limiters and that's why the mask is none
-
there's no other rules, this is the default one on LAN
I need to put limits on certain hostsAnd cut off everyone else? ???
I need to put limits on certain hosts, and I followed the instructions to set the limiters and that's why the mask is none
Which instructions? I cannot see any such instructions anywhere. Leaving the mask as "None" will create a guaranteed pipe for matching traffic, not actually enforce any limits.
https://doc.pfsense.org/index.php/Limiters
-
ok it's my first time so it's a bit confusing, I've a 10 Mb/s bandwidth and want to use it on the psfense and share it on the network but i want some hosts to be limited to 2Mb/s only even it's not used.
what are the steps to do that? -
-
I followed these steps as it is but still getting same results on speedtest.net
-
Then I guess you're out of luck. The guide is clear and it works for others, including myself when I tested it.
-
:-\
-
Just did a test and speedtest uses ICMP & TCP so you might want to change the protocol to ANY.
I don't think it will fix your issue.
Does it work it you limit the whole LAN interface is it even hitting the limiters goto Diagnostics -> Limiter Info and try a test.
I have my limiter set up as follows and it works fine :-
https://forum.pfsense.org/index.php?topic=124233.msg687137#msg687137
-
I met the same issues. Thank you guys! have a nice day!
