AT&T Mifi Setup
-
Hello!!!
I just recently purchased and setup an AT&T Unite Explore MIFI device. I currently have the device connected via USB to my pfSense box and used this command to configure it to an interface: usbconfig -d ugen3.7 set_config 1.
The above process is now working great and I am able to get mobile internet. I have two problems though:
-
How do I make the usbconfig -d ugen3.7 set_config 1 permanent so I do not have to input the command every time I unplug the MIFI unit?
-
How do I setup the device in IP Passthrough Mode so I can gain access to my hosted applications? (Right now, I am basically running two firewalls. One is the MIFI device and the other is my pfSense box.
When I try to do set the MIFI device in IP Passthrough Mode and USB Tether, my pfSense webui becomes unresponsive and I am unable to configure any further.
Thank you very much for the insight!
-Will
-
-
Any thoughts on this?
-
If you run it from shell then download the shellcmd app to pfsense and add the command to run at boot
-
Thank you very much for the reply kapara!
I have found these settings before and did not add them because this was on boot, not per device. If I unplug the MIFI device and plug it back in, will this command rerun?
Thank you!