no traffic shaping on NAT forwarded ports

[sirocco]

I found than shaper per IP works, but if I set external port forward for an IP - pfsense stops shaping this IP - outgoing queue exists but shows only part of traffic.

[hoba]

The shaper is stateful, so only new connectionas are assigned to a queue. Reset your states at diagnostics>states, reset state tab, and see if it works like intended after that.

[billm]

@sirocco:

I found than shaper per IP works, but if I set external port forward for an IP - pfsense stops shaping this IP - outgoing queue exists but shows only part of traffic.

Need more information for this.

Version
Screenshots of the port forward
Screenshots of the queues and rules

config.xml and /tmp/rules.debug would be helpful too

–Bill

[sirocco]

tcp/udp port forward from external 22105 to internal 192.168.105.105:22105
some other forwards to 192.168.1.2

internal network is 192.168.0.0/16

queues:
upload:

name: up105105
bw = 1%
priority = 1
m2= 25kB
RED,ECN,
qWanroot

other filelds are empty

download: the same as above but
name: down105105
m2 is empty
qLanroot

rule:
upload queue - up105105
download queue - down105105 (I found that specifying here qP2Pdown doesn't work)
LAN->WAN
protocol: any
source: 192.168.105.105 (single host)
rest of fields are empty/default

squid is running in transparent mode,

version: snapshot 25/03/2006

config-siroccofw1.local-20060405004147.xml.tar.gz.txt