netgate sfp+ 7100xg
-
I have two (2) netgate xg-7100 appliance and i am getting trouble configuring the option interface.
ix0 port on each device i assign ip address for the same network but still cant ping?
any idea?
-
Do the interfaces show as UP in Status > Interfaces? At the correct link speed?
Are they connected directly of via a switch? Do you see link LEDs?
What are you using to connect them with? DAC cable, Fibre module etc.
Steve
-
This post is deleted! -
This post is deleted! -
The Link sink up using Fiber 10g i assign ip address on the Fiber interface but its not pingable
-
Do you firewall rules to allow ICMP traffic on each end?
Steve
-
I did and will double check again!
-
It's easy to set them to TCP only by mistake.
You should see block entries in the firewall log if that's the case though.
-
Thanks i can ping the interface and because i am using it as a router i turn off packet filter.
i changed the parent interface for WAN to option1 (ixo) on both netgate appliance.
-
I have Fiber 10G module install and the line rate report the correct speed, do you no the actual throughput for the netgate 7100 i am using it as a Router!
Thanks inadvance.
Bquin
-
It depends what you're forwarding of course. It's not something I have tested myself (or is often used) but there are some numbers for forwarding only on the product page:
https://store.netgate.com/XG-7100.aspxSteve
