Netgate Discussion Forum
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Search
    • Register
    • Login

    netgate sfp+ 7100xg

    Scheduled Pinned Locked Moved Official Netgate® Hardware
    11 Posts 3 Posters 832 Views
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • stephenw10S
      stephenw10 Netgate Administrator
      last edited by

      Do the interfaces show as UP in Status > Interfaces? At the correct link speed?

      Are they connected directly of via a switch? Do you see link LEDs?

      What are you using to connect them with? DAC cable, Fibre module etc.

      Steve

      B 1 Reply Last reply Reply Quote 0
      • M
        mountainlion
        last edited by

        This post is deleted!
        1 Reply Last reply Reply Quote 0
        • stephenw10S
          stephenw10 Netgate Administrator
          last edited by

          This post is deleted!
          1 Reply Last reply Reply Quote 0
          • B
            bharlequin @stephenw10
            last edited by

            @stephenw10

            The Link sink up using Fiber 10g i assign ip address on the Fiber interface but its not pingable

            1 Reply Last reply Reply Quote 0
            • stephenw10S
              stephenw10 Netgate Administrator
              last edited by

              Do you firewall rules to allow ICMP traffic on each end?

              Steve

              B 1 Reply Last reply Reply Quote 0
              • B
                bharlequin @stephenw10
                last edited by

                @stephenw10

                I did and will double check again!

                1 Reply Last reply Reply Quote 0
                • stephenw10S
                  stephenw10 Netgate Administrator
                  last edited by

                  It's easy to set them to TCP only by mistake.

                  You should see block entries in the firewall log if that's the case though.

                  B 1 Reply Last reply Reply Quote 0
                  • B
                    bharlequin @stephenw10
                    last edited by

                    @stephenw10

                    Thanks i can ping the interface and because i am using it as a router i turn off packet filter.

                    i changed the parent interface for WAN to option1 (ixo) on both netgate appliance.

                    1 Reply Last reply Reply Quote 0
                    • B
                      bharlequin
                      last edited by

                      I have Fiber 10G module install and the line rate report the correct speed, do you no the actual throughput for the netgate 7100 i am using it as a Router!

                      Thanks inadvance.

                      Bquin

                      1 Reply Last reply Reply Quote 0
                      • stephenw10S
                        stephenw10 Netgate Administrator
                        last edited by

                        It depends what you're forwarding of course. It's not something I have tested myself (or is often used) but there are some numbers for forwarding only on the product page:
                        https://store.netgate.com/XG-7100.aspx

                        Steve

                        1 Reply Last reply Reply Quote 0
                        • First post
                          Last post
                        Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.