SG-1100 DEAD AFTER 2.4.5-RELEASE Upgrade!
-
18mins is significantly longer than I would have expected it to take in testing. However there are quite a few variables. The loading on the update servers is always high in the first few days after a release. Any packages you have installed will add to the time required. Your local connection speed could be anything.
It's good to get some real numbers from end users. Thanks Tom!Steve
-
@stephenw10 Just had my SG-1100 lockup. Had to pull power cord and force a reboot.
Routing stopped, could not login to the UI... Could ping gateway, but was not able to browse the internet.
pFSense is now backup and running. I went in to the system logs and copied the last 1000 records. Will send them to the support email you provided.
Here's a snip of the logs right before it locked up.
-
@costanzo FYI Created ticket: #INC-47998
-
Yup, opening a ticket is the correct thing to do there.
Steve
-
@serbus Take a read at this link that it was provided to me Today. it is an known issue. https://redmine.pfsense.org/issues/10414
-
Same problem frustrated with pfsense netgate 1100 and after update I pull out firewall i didn't know first I need wait f 15 10 minutes after 6 minutes I pulled plug out thank you netgate now have to wait for ticket for the firmware and also same problem with netgate my webgui pass stop working so I have to factory default first then fix password then update it then update crashes somebody needs to write you need to wait 10 30 minutes for the update.
-
I'm glad I found this thread. Mine took 17 minutes to reboot and I almost pulled the plug at around 8min, but wanted to see if others had long reboot times as well.
-
For me, the update went smoothly without any errors. However, the device took around 18 mins to reboot. I had seen this thread and therefore waited patiently. Its working fine after the update.
I am new to negate and I am surprised that it took so long. Is this pot update reboot time normal with netgate devices?
-
Same here :(
-
@computerpath said in SG-1100 DEAD AFTER 2.4.5-RELEASE Upgrade!:
somebody needs to write you need to wait 10 30 minutes for the update
https://www.netgate.com/blog/open-call-for-testing-pfsense-plus-and-ce-release-candidates.html
"The upgrade could take anywhere from 10 to 30 minutes. Do not remove power to your firewall while the upgrade is in progress."Agree it would be better if it was a 10 minute timer on the upgrade countdown page, or mentioned in the upgrade docs. Overall I think it depends heavily on the storage write speed.
-
@teamits
It has nothing to do with "boot".
It keeps booting up. I have a screen connected through serial port. Then I found that the operating system does not have enough memory, and can not perform the upgrade.
The IT support (support@netgate.com) was very competent, and helped me to reinstall. After 15min my Netgate device is working again.
