Installation on Infoblox 1550
-
Hey All,
I recently purchased an Infoblox 1550 with the intention of installing pfsense on it.
I used Rufus to create the bootable USB with serial output. I am able to boot to it and it appears to install fine to the internal sata disk but when I do a reboot and remove the USB nothing appears to happen apart from the standard infoblox POST.
I'm unable to access the Infoblox BIOS, do I need to flash them and if so is there any guidance on how?
If it's helpful at all here is the motherboard.
http://www.supermicro.com/products/motherboard/Xeon3000/3000/PDSMi-LN4_.cfm
The one installed has serial output only. I tried to boot to freeDos but was unable to do so on this machine, my guess is perhaps freeDos defaults to video output and not serial.