Problem With Control Bandwidth Internet Download Manager (IDM)
I have defined firewalls to control the bandwidth of users of the law
Users have access to the Internet at speeds
But if one of the users uses IDM, they will take all bandwidth and ignore the rules.
Why can not PFsense control IDM?
The number of connections in IDM is not controlled by PFsense?
@reza3sw which version you are using?
But it was a short-lived problem that was corrected in later versions.
I am currently using version 2.5.0 and this issue has been resolved.
@reza3sw Sir how to control IDM and uTorrent traffic using pfsense 2.5.0?
@aamiritincharge It's very simple. You have to define the restriction rules in Traffic shaper>Limiter and then write a rule for network users in the firewall>Lan section and enter the traffic shaper values in the advanced section.
@reza3sw I did it as you sir mentioned but it does not working....with IDM and uTorrent download files.
@aamiritincharge Tell us the rules you have defined so that we can identify them. Where is the problem ... Also which version are you using?
Protocol = Any
But you should use in/out pipe in advanced section Limiters rules
In limiters you could set two rules for limit bandwidth e.g: Upload and download
Then use those rules in advaced sectionin in/out pipe firewall rule
e.g : ( in: Upload and out: Download )
Did you do that?
@reza3sw I did that too... but does not working....with idm and torrent
In limiters rule you should use this paramatere
Mask : dest address
Ipv4 mask : 32
Ipv6 mask: 128
Queue manag: Trill drop
Like download but change mask to source address
Which version pfsense using?
@reza3sw i have set it as "Worst Case Weight fair Queuing".....does it was this issue?