Auto configuration backup shows no backups - us too
-
Re: Auto configuration backup shows no backups
We are experiencing the same problem since the upgrade to 2.4.4. Is there a fix?
-
Hi,
Fixing what ?
Show us your settings, so others can advise you about how to correct, or "fix" them.The new free, Services => Auto Configuration Backup => Restore works for me. The logs (most recent lines are at the bottom) are actual.
-
Have you renewed your Gold membership?
-
@tim-mcmanus said in Auto configuration backup shows no backups - us too:
Have you renewed your Gold membership?
Why?
https://www.netgate.com/blog/pfsense-2-4-4-release-now-available.html all former Gold member avantages is free of use now.
So is the (ex) package AutoBackup : it's build-into pfSense now.
After a small setup, it works (as long as pfSense has a working WAN connection) -
@gertjan said in Auto configuration backup shows no backups - us too:
@tim-mcmanus said in Auto configuration backup shows no backups - us too:
Have you renewed your Gold membership?
Why?
https://www.netgate.com/blog/pfsense-2-4-4-release-now-available.html all former Gold member avantages is free of use now.
So is the (ex) package AutoBackup : it's build-into pfSense now.
After a small setup, it works (as long as pfSense has a working WAN connection)Wasn't aware of that. In the past, the RC was usually an expired Gold membership. Thx for clarifying.
-
The thread I referenced is the exact problem that we are experiencing. The New AutoConfig Backup is not working for us on two of our devices. The only difference is that if I plug in the device ID of the one that works into a non-working unit, I cannot pull of the backups from the working device either.
The config on these two devices is using CARP in a high availability scenario. Is it possible that this is screwing up the backups?
-
I just noticed that we are also getting this error: A communications error occurred while attempting to call XMLRPC method restore_config_section: @ 2018-11-12 10:26:12
-
Now I notice that the Backup & Restore on the Diagnostics tab seems to be working like the Autoconfig Backup. Was Autoconfig backup merged or replaced with Backup & Restore? I never use Backup and Restore because it was manual, now it seems automated?
-
This post is deleted! -
Problem has been resolved. Since these units are MultiWan, we found that when the gateway changed, neither unit could resolve DNS internally, preventing them from reaching the ACB Servers. By adding gateways in the System > General Setup > DNS Server Settings and associating different DNS servers with each gateway, we were able to restore the connection and now all is working.