SG-1100 WAN MAC Spoofing Guide?
-
Hello!
Is there a step by step guide that describes what steps are needed to perform MAC spoofing on the WAN interface of an SG1100? I have looked at a couple related articles but none of them seem to provide complete directions? Any help is appreciated, thanks!
-
Not sure if there's anything different with the SG1100 but all I do to spoof the WAN MAC on my pfsense install, is go to Interfaces->WAN and enter the MAC I want to use in the MAC Address field.
-
I was looking at that and it is a a field I cannot click/modify. I get the following message from that screen:
The MAC address of a VLAN interface must be set on its parent interface
Edit: I can't click/edit this red box
-
I think these are the relevant system settings but not sure where to actually modify the MAC address setting for the parent:
-
You have to set the mac on the actual physical interface.. Not a vlan interface.
-
Or from command line: ifconfig mvneta0.4090 ether xx:xx:xx:xx:xx:xx
-
that is not going to stick..
-
@johnpoz True.
To make it 'stick' You can put this it in /etc/inc/interfaces.inc:
mwexec("/sbin/ifconfig mvneta0.4090 ether xx:xx:xx:xx:xx:xx");
-
@johnpoz Thanks! Any guidance on where I can set the physical interface from within the web interface?
-
Interfaces > Assignments
Add an interface for mvneta0
Edit the interface, enable it, spoof the MAC address, but do not number it. Leave IPv4 and IPv6 set to None.
