Nat and Filtered Bridge



  • I have Filtered bridge Ethernet->-Ethernet and Traffic Shaping
    How i can NAT specific IP addresses?

    Example i have host 10.0.0.25
    pfSense - 10.0.0.3
    Virtual IP - 10.0.0.30

    I want NATting HTTP
    from 10.0.0.25 ->trough (lan) side-> 10.0.0.3 ->as (wan) side-> 10.0.0.30

    If it's possible - how detailed this make?
    VirtualIP type, wan or lan side, NAT rule on lan or wan side? …

    Pls help, or knock where look?



  • Can't make rule - all variant's not worked  :'(

    icmp 10.0.0.21:512 -> 194.87.11.112 0:0
    tcp 10.0.0.3:80 <- 10.0.0.21:4977 FIN_WAIT_2:FIN_WAIT_2
    tcp 10.0.0.3:80 <- 10.0.0.21:4979 FIN_WAIT_2:FIN_WAIT_2
    tcp 10.0.0.3:80 <- 10.0.0.21:4990 FIN_WAIT_2:FIN_WAIT_2
    tcp 10.0.0.3:80 <- 10.0.0.21:4996 ESTABLISHED:ESTABLISHED
    tcp 10.0.0.3:80 <- 10.0.0.21:3007 FIN_WAIT_2:FIN_WAIT_2
    tcp 205.189.214.250:80 <- 10.0.0.21:3015 CLOSED:SYN_SENT
    tcp 10.0.0.21:3015 -> 10.0.0.3:50325 -> 205.189.214.250:80 SYN_SENT:CLOSED
    udp 10.0.0.21:3002 -> 10.0.0.3:51822 -> 192.168.2.20:53 SINGLE:NO_TRAFFIC
    udp 10.0.0.21:1103 -> 10.0.0.3:52415 -> 192.168.2.20:53 SINGLE:NO_TRAFFIC
    udp 192.168.2.20:53 <- 10.0.0.21:1103 NO_TRAFFIC:SINGLE
    udp 192.168.2.20:53 <- 10.0.0.21:3002 NO_TRAFFIC:SINGLE
    udp 192.168.2.22:53 <- 10.0.0.21:1103 NO_TRAFFIC:SINGLE
    udp 192.168.2.23:53 <- 10.0.0.21:3002 NO_TRAFFIC:SINGLE
    udp 10.0.0.255:137 <- 10.0.0.21:137 NO_TRAFFIC:SINGLE
    udp 10.0.0.21:1103 -> 10.0.0.3:62050 -> 192.168.2.22:53 SINGLE:NO_TRAFFIC
    udp 10.0.0.21:3002 -> 10.0.0.3:53304 -> 192.168.2.23:53 SINGLE:NO_TRAFFIC
    udp 10.0.0.21:137 -> 10.0.0.3:53734 -> 10.0.0.255:137 SINGLE:NO_TRAFFIC

    Rule NAT
    interface:WAN  src:10.0.0.21/32  dst:ANY trans:INTERFACE ADDRESS
    all ports=any(blank)

    This rule i copy from default and change src


Locked