pfSense hangs on boot

mstrolo

hello i need your help

we had a power down and after that ofsense is stuck in boot
on Configure wan interface

and its not starting the system.

any idea what can i do?

NollipfSense

@mstrolo It seems that WAN isn't getting an IP ... check that the cable is plugged in and seated firmly then reboot your modem then pfSense.

mstrolo

@nollipfsense did that but nothing happens

stuck on that line

mstrolo

@nollipfsense and its not hardware
cuz iv run windows 10 from usb and all interfaces are up and have connection

Gertjan

@mstrolo

When that line is reached, or just a bit before that, when you take out the WAN cable, do you see the bold "link state changed DOWN / UP" messages ?
What happens when you boot without the cable ?
What happens when you re assign the interfaces : swap LAN and WAN ?
Is this a bare bone or VM ?

stephenw10

What is your WAN interface? How is it configured?

This same setup was working OK before the power outage?

Steve

mstrolo

hello guys
so whats going on right now is that if am doing a fresh install
pfsense is working and booting up
but one i try to put wan port on ppoe and the device does restart
it hangs on the wan dhcp thing

any ideas?

mstrolo

@stephenw10 yes i was worked perfect
look at my latest replay

mstrolo

@gertjan as long as i dont configure Wan Port with DHCP or PPOE
system works fine

the min ... i put ppoe and it does refresh system stop responding and after reset stays on that line

and yes i see link up