Normal Operating Temp NG-4200

[TechGuyTnE]

Thank you for response.

The device is sitting on my desktop. All of the case vents are unobstructed. The ambient temperature of the room has been right around the 75F (25C) range, give or take.

The fact that it's passively cooled was one of the reasons that I bought it.

Thanks again for your reply. Super helpful to know where to find a breakout of the core temps and the specs on the chip itself.

[alleykat]

@TechGuyTnE My new 4200 is on my desk in my "home lab", nothing sitting on top of it, nothing sitting below. Room temp is 76-77 degrees F. The 4200 is running at 63F, cpu at 8%. I thought mine was high also. I just have the "stock" packages running with the addition of haproxy.

[stephenw10]

@alleykat said in Normal Operating Temp NG-4200:

The 4200 is running at 63F, cpu at 8%

63°F is only 17°C which seems unlikely. And also very cool! Do you mean 63°C?

If so where are you seeing that?

[alleykat]

@stephenw10 Yes, I'm sorry, 63C, lol.

[stephenw10]

Hmm, that does seem warm. Where are you seeing that value? On the core temps directly?

[alleykat]

This post is deleted!

[alleykat]

@stephenw10 This is where I'm seeing the temp.

[stephenw10]

Hmm, odd. You may need to reset the RRD data.

What does the thermal sensors widget show?

[alleykat]

@stephenw10 I'm now thinking I made it switch from my 2100 to the 4200 on May 29. Maybe the config from the 2100 still needs more changes. I made the interface assignments with a text editor to the config xml and loaded it on the 4200. So far so good, first issue I've ran into. Do you happen to know, was there other areas in the 2100 config that needed to be changed?

[stephenw10]

You may not have Speedshift enabled in Sys > Adv > Misc since the 2100 doesn't have that. That will bring down CPU temps.

[alleykat]

@stephenw10 Speedshift is already active (checked). Control level Core. Power Preference, slider in the middle.

How do you reset RRD?

[alleykat]

@TechGuyTnE Sorry TechGuy, I didn't mean to "highjack" yout thread...

[stephenw10]

@alleykat said in Normal Operating Temp NG-4200:

How do you reset RRD?

In Status > Monitoring > Settings (Advanced).

The default value for SpeedShift is 80.