1.2.3-RC3 to 1.2.3-RELEASE breaks WAN-OPT1 bridge?



  • I upgraded to the RELEASE version from the last release candidate - the upgrade process went fine except that my WAN-OPT1 bridge seems to allow traffic in, but not out, after the installation.  No obvious reason for this that I can see so far.

    A separate RC3 to RELEASE upgrade on an embedded Alix system (without an OPT port) worked fine.



  • Fixed now.

    I had entered a Gateway address to the OPT1 IP configuration when I was getting the WAN-OPT1 bridge  working under the prior RC3 version.

    Clearing the Gateway address field seems to have fixed the problem.


Log in to reply