No Option for LAN interface during installation
-
I was playing with 2.0 BETA 4 today and I found that the installer only asked me for WAN interface, not the LAN interface anymore.
I can access the WebGUI through WAN port, but WebGUI was dead after I tried to enable LAN interface.
Is there a way to setup LAN interface during installation process for pfSense 2.0?
-
It should prompt you to assign WAN, LAN, and any OPTs during the install process automatically.
Some work was done on the console code this week though - can you try a snapshot from a couple days ago and see if it behaves differently?
-
I just booted up today's snapshot and it asked me for WAN, LAN, and OPT interfaces as expected.
Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.