Load balancing and failover in pfsense 2.0 RC3

[pankaj]

hi,

Please help in configuring load balancing and failover. I searched hard on the net regarding this but could not found the solution. please helpppppp :(

[Nachtfalke]

Then try to search the forum.
"multiwan" and "LoadBalancing" could help you. "routing group" will help you, too.

[jimp]

Check the board here for 2.0. It's in a sticky post there, and all over the forum.

[pankaj]

No…still did not found any solution. first of all i want to tell you that I am able to browse with single wan1 link that was configured at the time of installation of pf sense. but when I attached another wan2 link, browsing stopped. even removing of default wan1 connection browsing does not start. I am also attaching some screen shot of my pfsense configuration. Please help.

1st image is of my dash board

[pankaj]

2nd screen shot is of my dns server configuration in general setup

[pankaj]

screen shots of system gateway and system gateway groups

[pankaj]

screen shots of firewall rules in floating and lan

[pankaj]

screen shots of status gateways and gateway groups

[pankaj]

screen shots of my squid guard proxy configuration

[Nachtfalke]

I am not familar with squid and load balancing on one machine.
Is LoadBalancing working if you use it WITHOUT squid installed ?
Without squid you do NOT need floating rules, just the LAN rule you added.

[pankaj]

actually I did not check it without squid in 2.0 but it was not working in 1.2.3 :(

[pankaj]

i checked without squid…it is not working in pfsense 2.0 rc3 also ???

[Nachtfalke]

can you show us your OPT1 interface options ?

[pankaj]

sure here it is…both opt1 and wan