Routing Traffic through Specific WAN



  • I have a setup with dual PPPoE WAN and I am trying to find the correct way to route traffic per application to specific WAN.

    Let's say I want to make SoulSeek that uses port 1369 to pass through WAN 2.

    Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?

    Where do I put the port, Source port range or Destination port range?

    Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?

    Any tips are greatly appreciated cause I'm not really a network guru, trying to figure it out with any info I can get on the forums.


  • Rebel Alliance

    q: Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?

    a: yes

    q: Where do I put the port, Source port range or Destination port range?

    a: destination

    q: Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?

    a: yes incoming will use the same wan ip, not need any rule



  • That was fast! Thanks a Lot  ;D


Log in to reply