Routing Traffic through Specific WAN
-
I have a setup with dual PPPoE WAN and I am trying to find the correct way to route traffic per application to specific WAN.
Let's say I want to make SoulSeek that uses port 1369 to pass through WAN 2.
Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?
Where do I put the port, Source port range or Destination port range?
Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?
Any tips are greatly appreciated cause I'm not really a network guru, trying to figure it out with any info I can get on the forums.
-
q: Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?
a: yes
q: Where do I put the port, Source port range or Destination port range?
a: destination
q: Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?
a: yes incoming will use the same wan ip, not need any rule
-
That was fast! Thanks a Lot ;D
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginPrivacy Policy · Cookie Policy