ALIX flash install or web upgrade of 2.0 completes but no IP to connect to.



  • I must be missing something simple, but if I install 2.0 fresh(or upgrade from 1.2.3) I don't see how to configure the LAN IP from Serial Console, all I get is this in the console:

    PC Engines ALIX.2 v0.99h
    640 KB Base Memory
    261120 KB Extended Memory

    01F0 Master 848A SanDisk SDCFJ-512
    Phys C/H/S 993/16/63 Log C/H/S 993/16/63

    BIOS setup:

    9 9600 baud (2) 19200 baud (3) 38400 baud (5) 57600 baud (1) 115200 baud
    C CHS mode (L) LBA mode (W) HDD wait (V) HDD slave (U) UDMA enable
    (M) MFGPT workaround
    (P) late PCI init
    R Serial console enable
    (E) PXE boot enable
    (X) Xmodem upload
    (Q) Quit

    Save changes Y/N ?
    Writing setup to flash… d    f¼@    PC Engines ALIX.2 v0.99h
    640 KB Base Memory
    261120 KB Extended Memory

    01F0 Master 848A SanDisk SDCFJ-512
    Phys C/H/S 993/16/63 Log C/H/S 993/16/63

    1  FreeBSD
    2  FreeBSD

    Boot:  2
    /boot.config: -h
    Consoles: serial port
    BIOS drive C: is disk0
    BIOS 640kB/261120kB available memory

    FreeBSD/i386 bootstrap loader, Revision 1.1
    (root@FreeBSD_8.0_pfSense_2.0-AMD64.snaps.pfsense.org, Tue Sep 13 17:52:09 EDT 2011)
    Loading /boot/defaults/loader.conf
    /boot/kernel/kernel text=0x8663b0 data=0x3ff908+0xbe798 syms=[0x8+0xda178+0x8+0xc796a]

    Hit [Enter] to boot immediately, or any other key for command prompt.
    Booting [/boot/kernel/kernel]…
    CPU doesn't support long mode

    Type '?' for a list of commands, 'help' for more detailed help.
    OK ?
    Available commands:
      heap            show heap usage
      reboot          reboot the system
      autoboot        boot automatically after a delay
      boot            boot a file or loaded kernel
      lsdev            list all devices
      more            show contents of a file
      read            read input from the terminal
      echo            echo arguments
      unset            unset a variable
      set              set a variable
      show            show variable(s)
      ?                list commands
      help            detailed help
      include          read commands from a file
      ls              list files
      lsmod            list loaded modules
      unload          unload all modules
      load_geli        load a geli key
      load            load a kernel or module
      bcachestat      get disk block cache stats
      pnpscan          scan for PnP devices
      smap            show BIOS SMAP
      boot-conf        load kernel and modules, then autoboot
      read-conf        read a configuration file
      enable-module    enable loading of a module
      disable-module  disable loading of a module
      toggle-module    toggle loading of a module
      show-module      show module load data
    OK



  • You need to install an "i386" kit on an Alix. You are attempting to run an "amd64" kit which was built to run on a CPU supporting "64 bit" instructions. The CPU on the Alix doesn't have "64 bit" instructions.


Locked