Run0 not working
-
If it's stuck at "Configuring WAN.." leave it there for 10 minutes, it should boot up properly after a while. I had similar experiences with a few of the older snapshots (https://forum.pfsense.org/index.php?topic=83981.0). Last few updates I've done seem to be ok.
-
FYI, it didn't work, i'm using rt3072 in case that helps.
-
I can confirm that. But mine 3072 have never been working with pfsense properly. I've tried to use it as an optional interface and it hangs at "Configuring… "
Some builds before it just did kernel panic at this point. -
it used to work well, back when 2.2 beta was first released, up until about a month or so after.
-
run0 still works pretty well for me since first 2.2 snapshot
-
ya well, what module are you using? Maybe this could be specific to rt3072 then…
-
I've attached the screenshot of pfsense that is hangs right after configuration changes.
Mine card is USB "edup ep-ms1532" that uses according to found photos of sssembly RT3072L chipset.
pfsense does not show me "n" mode settings so I guess it tries to load some old crappy driver on it.
I'll try to put this card on some newer freebsd build later to check if it's driver.
-
it's not working in clean FreeBSD 10.1 also.
-
Since it's a BSD problem, i've continued this thread on the freebsd-wireless list:
http://lists.freebsd.org/pipermail/freebsd-wireless/2014-December/005291.html
-
have you ever tried to ADD WIFI interface thru Web Configurator ?
-
If I understand correctly what are you asking, yes we have tried it many times.
-
I have seen the screen you're posting many times as well. Can you make Interfaces-Assign screenshot and post it here ?
-
It won't show anything useful, what is it you're looking for exactly? This is almost certainly a BSD bug, replying to the thread on there would be the best way to troubleshoot this.
