SuperMicro A1SRI-2558F - Flashing LED - Help please



  • Hello,
    pfSense newbie here.

    I just built a pfSense device for home use.
    Below is the hardware info:

    A1SRI-2558F board, 4GB Kingston RAM, Antec ISK 110 VESA Case with PSU and Kingston SSD V100.

    When I turned on the system, I see a blinking green led. The manual doesn't have enough information about this.
    I can log into the system and set up everything.

    I Googled this, where someone mentioned that it is the IPMI hearbeat, but I would like to have a confirmation on this.

    Having said that - I would happy to run and post any benchmarks on this build.

    Thank you.
    -D



  • When I turned on the system, I see a blinking green led. The manual doesn't have enough information about this.

    Which LED is blinking and where, please? Would you please come closer to this point.

    I Googled this, where someone mentioned that it is the IPMI hearbeat, but I would like to have a confirmation on this.

    It might be more so that the IPMI port was not configured in the BIOS, or?
    In some cases the IPMI port is configured as the or a WAN fall back port, could this also matching
    to your configuration?



  • Take a look at hte manual and search for LED2.

    If that's LED you're talking about then yes, that's the BMC heartbeat.  The BMC is a component of IPMI.

    My 2758f has the same heartbeat.



  • BMC heartbeat…



  • Do you use ECC ram modules?


Log in to reply