pfSense console setup 0)  Logout (SSH only) 1)  Assign Interfaces 2)  Set LAN IP address 3)  Reset webGUI password 4)  Reset to factory defaults 5)  Reboot system 6)  Halt system 7)  Ping host 8)  Shell 9)  PFtop                          <–-------------------------------- I'm talking about this option at the CONSOLE menu, not the webgui. 10)  Traffic Logs Enter an option: You can access it via ssh as well if ssh is enabled at system>advanced in the webgui.

@hoba: Actually this bug could derive from two for the next version already fixed bugs: 1. "no scheduler specified": earlier versions had support to select different schedulers. that support was dropped. The setting could be found at the advanced settings page. Due to a non complete removal this error could pop up if you save advanced settings AFTER you have run the shaper wizard. This is fixed in CVS 2. "qwanroot has no parent": This could be cause by not having a bandwidth set at your wan interface in the bandwidthfiled at "Interfaces>WAN". Please check that setting and set it to 10 mbit/s if you have a nic running at 10 mbit there or 100 mbit/s if the link is 100. This also is fixed in the new upcoming release and won't be necessary with this new version. So: Check WAN Bandwithfield, then run the shaper and don't save advanced settings after that and you should be fine for now….hopefully  ;D Next version won't need these workarounds. You are right I don't have it set!  I have been meaning to set that option too.  I don't have it set for Lan either so my traffic shaping is probably not working so well. I think I will do a clean install on the next version,  I just hope I can remember all my settings :). Thanks for your help.