No connection on WAN port
-
I have a hard time getting pf sense to work.
I have got a DrayTek Vigor 130 as a modem in bridge mode. The device was pretty much set up.
I just changed the VLAN Tag to 0 made sure PPPoE was disabled and MPoA and bridge mode was enabled.
I put in my DSL cable and a Ethernet cable to connect to my pfsense.On the pfsense I setup the WAN port o be PPPoA. I entered my credentials and turned dial on demand on.
After that I created a VLAN 7 and under PPP I configured it to use the VLAN interface and entered my credentials once more.However I can't get a connection on my WAN port.
The WAN interface shows a free arrow and the status is "uptime: -" and where the IP should be it says n.a.
I called my ISP and the said the modem did successfully connectedBelow are some pictures of my config
https://imgur.com/a/aXfjwlz -
That looks OK as long as the ISP is expecting VLAN7 and the credentials are correct.
Are you sure the modem is not re-tagging the traffic as VLAN0? I would try setting the VLAN tag to 7 there and using the untagged interface in pfSense.
Steve
-
@stephenw10 so you mean setting the VLAN to 7 on the modem and then just setting up the WAN interface using PPPoE and that's it?
And what do I set under Assignments -> PPPs -
Yes, set the VLAN in the modem and just use the parent interface in pfSense. So re1 in your case.
Steve
-
@stephenw10 Ok, my ISP uses DS-Lite so I don't have a real IPv4. I set "None" for the IPv4 Configuration type and now the WAN interface shows a green arrow and 1000baseT<full-duplex> but no IP Adress
-
The WAN must still be set to PPPoE to authenticate. Just that the ppp config is now on re1 rather than re1.7.
Steve
-
@stephenw10 thanks for your help. I ultimately switched back to my Fritzbox and activated PPPoE-Passthrough on it and connected pfsense to it. It now gets an IPv4 Adresse and everything is working.
-
Can you see how the VLAN is configured there?
-
@stephenw10 I guess there is VLAN configured because I didn't need to set it on the pfsense