Amber light after Netgate 4100 firmware upgrade
-
@Gertjan TAC support's verdict was "Terminal harware failure". Seems like I can use the power supply and the SSD for something else. That's what's left.
-
If you haven't already try removing the CMOS battery.
-
Try running pkg clean and pkg update and pkg upgrade on command line
-
@stephenw10 I tried this already
-
The board has some internal diagnostic LEDs near the console port. If it is powering up correctly it should look like:
-
@stephenw10 It looks like the one on your image
-
Hmm, not a hardware power problem then.
If you just leave it powered does it eventually do anything?
-
@stephenw10 I left it overnight - nothing
-
Hmm
-
Do you try to remove the SSD and use the eMMC Flash?
-
@NOCling No, It doesn't show any BIOS/boot related messages in the serial console. Just a black screen.
