Pfsense blocking Playstation network on my ps4 and 3 and other phone apps
-
OK, system - advanced - network
Check disable hardware checksum offload
Save
Reboot -
I removed the posts with all the dump info in them - impossible to get any useful info off of those... The actual pcap file is what is needed which you linked too.
From a quick look.. why does .251 send so many RST.. Seems like a really shitty way to close off a conversation.. They seem to be after fin as well.. And then it has more conversations from the same source port?
Going to take a bit to try and go through this sniff... But its not really complete.. You really should have a sniff of when the ps4 turns on.. There are conversations that start was missed..
-
still same problem
-
@davidserverguy2019 show output ifconfig bge0 and
Ifconfig bge1 -
https://www.dropbox.com/s/7fort68kyjkikk5/IPconfig%20bge0.txt?dl=0
https://www.dropbox.com/s/qp7v83k7coxsqss/IPconfig%20bge1.txt?dl=0 -
@davidserverguy2019 OK, show, please, status/interfaces
-
@johnpoz New Capture below
https://www.dropbox.com/s/eqp5f7he50wd311/packetcapture.cap?dl=0 -
@konstanti here you go
https://www.dropbox.com/s/57a7sak8eb7xz24/20181230_102038.jpg?dl=0
-
Ok this is odd... So here is the ps4 talking to UPnP and getting your public IP... That gets answered..
But what is odd is why the retrans and dupack and out of order stuff.. This ps4 is wireless? Can you wire it?
There is a shit ton of RST from the ps4?? Seems ODD..
-
When you say this works on your old router - your connecting to your old routers wifi?
-
@davidserverguy2019 Try to do so
- Interfaces-wan-mtu 1400,
2 system-advanced-networking- leave it checked "disable hardware offload checksum"
3 setup MTU to 1400 on PS
or you can MTU check here
http://www.speedguide.net/analyzer.php - Interfaces-wan-mtu 1400,
-
@johnpoz yes wireless on my old router well i have switched wireless off and use my unifi access point for wireless
-
@davidserverguy2019 said in Pfsense blocking Playstation network on my ps4 and 3 and other phone apps:
I am on fibre
Then just grab an Openreach modem off ebay. The later ECI type seems more reliable especially if it gets hot. That is what I'm using with Plusnet right now.
Steve
-
@konstanti with that setting internet does not work at all
-
@davidserverguy2019 Ok ,
1 wan-interfaces -mtu 1492 (default setting)
and
2 ps4 mtu 1492PS4 showing error code ?
-
still fails do you want me to do a capture with wired?
-
@johnpoz still fails do you want me to do a capture with wired?
-
So it fails over wired as well?
Be good to see a capture that works, to compare too.. There seems to be a lot of RST and dups and retrans via your wireless..
But sure a wired capture could be helpful.. Can never have too much info ;)
-
https://www.dropbox.com/s/ot3p415t1s220k1/packetcapture.cap?dl=0
I have noticed the ps3 is now working so will do a capture of that
-
@johnpoz here is PS3 cap
https://www.dropbox.com/s/psbzvk8b0oqst89/PS3packetcapture.cap?dl=0
