Install to disk: Won't boot
-
Newb here…
I'm installing pfsense 1.2 to the hard drive of a cisco 500 series content engine.
Everything goes great until I get to the point where I must reboot and remove the cd.
I am then greeted with:
**F1 Linux
F5 Drive 1Default: F1**
The machine then beeps every few seconds and will not accept any input from the keyboard.
Any advice? What am I doing wrong?
-
Found the problem. These cisco devices have a simm card in them that it tries to boot off. Pulled it out and now all is good.
Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.