Upgrade to 2.4.4p2 - SG-3100 won't boot
-
I was doing an upgrade from 2.4.4 to 2.4.4_2 via the web interface. The packaged downloaded and I received an "Install Successful" message. When the SG-3100 rebooted, it did not complete and the left two lights are blinking.
I have connected to CLI and executed boot.
The system executes a large number of rm: commands and eventually hangs.
Any assistance is appreciated!
-
I had to do a re-install of 2.4.4_2 from USB.
Now I need to figure how to access my saved configuration from the AutoConfigBackup package. I'll post in that forum.
-
For the future I suggest you to always take a manual Backup in the WebGUI before you do the Upgrade.
Personally I do manual Backups before any Config change. It takes 2 seconds of my time but let me sleep much better.
-Rico
-
Yes, lesson learned.
