@jelter:
Just wondering if you ever got this working. I have been struggling and have tried much of the same.
I actually did get this working, as far as the VPN interface getting an IP address (if you need these settings, PM me), but I can not route anything through it to the outside.
My goal is to define specific LAN traffic to go out the interface.
Current setup:
WAN (Comcast): 73.82.XX.XX
LAN: 10.0.0.0/24
VPN IP: 100.97.0.40 Remote IP: 162.250.2.18
Note the VPN IP changes very often, maybe once every 5 mins. Probably normal but I figured I would mention.
I've looked over several guides on how to set up routing (created manual NAT rules, etc), but when I tell it to route all LAN traffic through the VPN interface, nothing goes out.
When I do ping tests from withing pfSense (Diagnostics/Ping):
WAN->VPN IP success
LAN->VPN IP success
VPN->WAN IP success
VPN->LAN gateway success
VPN->any internet IP fails
VPN->Remote IP fails
(Should the above two lines work?)
Rules:
Tiger_VPN
Protocol: IPv4
Source: *
Port: *
Destination: *
Port: *
Gateway: *
OpenVPN:
Same as above except:
Source: LAN net
Gateway: TIGER_VPN_VPNV4
WAN/LAN rules: Currently nothing involving VPN
Pending rule added to top of the list (which doesn't work - no net traffic goes out the VPN interface):
LAN
Protocol: IPv4 TCP
Source: *
Port: *
Destination: *
Port: *
Gateway: TIGER_VPN_VPNV4
It seems a lot of people are getting stuck at this point where nothing routes through the VPN interface to the internet. Just seeing if I'm missing any rules here.