@stephenw10 Thank you!

I found that the "DTBFAT0" partition is the partition that works.
pfsense-recovery-firmware-usb-drive.jpg

You should be able to just select all the defaults for the 1100. The installer detects that and sets defaults appropriately.

That should be fixed. If you do see it again reinstall the Wireguard package.

@good4y0u it needs the password and device key:
https://docs.netgate.com/pfsense/en/latest/backup/autoconfigbackup.html#bare-metal-restoration

No, not unless you have some boot issue that requires the use of the secondary table.

However you can try to use growfs to fill the disk if you wish. Run: touch /root/force_growfs then reboot and it should fill it during the next boot.

@andy58 I agree! there should be a disk space check command issued before update starts.

Yes, probably. Check the RAM usage. Check available disk space.

@dgall There is a new (beta) Installer:
https://docs.netgate.com/pfsense/en/latest/solutions/xg-7100/reinstall-pfsense.html

@pixel24 said in No Update 2.8.0 available:

@Gertjan I've never worked with the Pathes package before. I've always installed updates exclusively through the web UI.

That is for program updates. Netgate releases fixes in between version updates. They are normally included in the next version. They often backport security fixes.

@stephenw10 Hello,
The device has only two nics but when I installed pfsense plus they were detected right away properly as active and was able to choose WAN and LAN and it was good a detecting internet on the WAN interface. In any case it is working now. Thanks

@SteveITS @jimp
Ok thanks, I applied all the patches and performed the normal system reboot. Everything seems to be working fine.

Sophos XGS 87 is not supporting pfSense.

Bless

@stephenw10

The inclusion of the pfSense-repoc package in the command below + the temporary removal of Snort and pfblockerNG did the trick.

pkg-static clean -ay ; pkg-static install -fy pkg pfSense-repo pfSense-repoc pfSense-upgrade

Happily running on version 24.03 now. Cheers!

@SamJWard Hmm... they don't have monitoring system in place to notify their server admins that the systems are down? Would be nice if they have a network status page on the netgate support site in cases like this so we don't waste time trying to figure out if there is something wrong with our pfsense / netgate appliances like I dealt with today. This would also prevent un-necessary tickets.

Yes I am a bit frustrated to spend couple of hours troubleshooting only to find out it wasn't my instance. Although I am used to it in the IT world.

Least now I know after finding a couple of posts about this that I can stop troubleshooting and wait till in the morning to try again.

Hmm, yes that should not need to be registered and should always return as eligible.

Send me the NDI and serial in chat and I can check it. Or open a TAC ticket: https://www.netgate.com/tac-support-request

More info needed.

If you're running ZFS you can roll back the BE, yes. But that also means it upgraded and verified the boot or it would have rolled back automatically.

So if the upgrade was successful that implies some other failure in the new version. It failed to pull an IP address?

OK so it's trying to use something in pkg that doesn't exist in 2.4.5.

So, again, what update branches do you see offered in the GUI?

2.4.5 to 23.01 is too large a jump. You will probably need to upgrade first to something closer to 2.4.5.

Send me your NDI and/or Order number in chat and I'll check it.

Steve

@stephenw10

I will try to uninstall and then install it via "pkg upgrade" again.