VAR out of space - Ram disk setting does nothing
-
I searched and found no solution.
I am not apposed to disabling RAM Disks either, however after trying that I am still out of disk space. Is there any easy way to increase the disk size. Not sure what I am to do here.
-
@ngr2001 If you disable the RAM disk you’re still out of space? You should have the 112 GB. Get a bigger disk or figure out what’s using so much…?
-
What pfSense version is that?
-
PFSense Plus
-
I disabled the RAM Disk and rebooted and now its still looks like this
That doesnt seem to make sense to me.
I am running Suricata, I turned on log management but the 60Mb partition is still showing full.
-
@ngr2001 Are other changes retained after restart?
FWIW here is the other thread:
https://forum.netgate.com/topic/195486/changes-to-ram-disk-size-not-affecting-actual-filesystem-size/11 -
Yeah I was thinking the same, it does seem likely to be the same cause. It's using the default values for the sizes there. I wasn't able to replicate it either.
Have you upgraded to 24.11 or is it a clean install?
Was it upgraded from CE?
-
Clean install from a bootable usb stick. Was never upgraded, started as plus never ce.
-
Hmm, OK. At some point you did deliberately set RAM disks enabled though? But now there seems to be no way to disable them?
-
That is correct.
In this case, I installed PFSense Plus clean from USB Boot stick. I then hand applied all my desired settings. Out of habit, the 1st thing I normally do after install is configure the RAM Disks. Only reason being, to extend the life of the SSD.
-
Seems like other settings on the System - Advanced- Miscellaneous -
page are working. For example I enabled PowerD & QAT, both are working after reboot.Other Settings:
Evidence Working:
-
@ngr2001 Is the setting in the config file the 40/60 or what you set?
-
Which config file, not sure what you mean / asking.
I did clean normal install, next through all defaults. On 1st boot I enabled RAM Disks and set to 512Gb each, however that never took effect. It;s been stuck at 60Mb since install. I disabled RAM Disks, and its still shows 60Mb.
If there is a file you would like me to check let me know.
-
@ngr2001 Diagnostics/Backup will download it.
-
Could be some variation of this: https://redmine.pfsense.org/issues/16023 Though I've never seen that in 24.11.
If so it should be fixed in the next 25.03 build.
-
RAM Disk is disabled currently, my backup config shows the bellow 2 values:
<use_mfs_tmp_size>512</use_mfs_tmp_size>
<use_mfs_var_size>512</use_mfs_var_size> -
When does that come out, anything I can do in the mean time ?
-
@ngr2001 It’s been in beta for a while:
https://forum.netgate.com/topic/196342/pfsense-plus-25-03-beta-is-hereVague guess, a week or two after an RC version so maybe in a month, give or take.
-
If I wasn't going to use RAM Disks, is there an easy way to increase the disk partition size ?
-
Without RAM disks /var should have access to the entire root partition on the drive. So pretty much unlimited for most situations.
With RAM disks disabled the config should still contain the previously set sizes, so they can be recalled later. It just shouldn't contain:
<use_mfs_tmpvar></use_mfs_tmpvar>
