Web configurator problems
-
Hi all,
I've just installed 2.0 RC1 on a Dell PowerEdge 1850. This server was previously in production using v1.2.3 and running fine.
I don't get far into the web configuration before I start having issues…
The 1st thing I did is go to the Advanced tab and set the notification info for email. When clicking save, it takes between 30 - 45 seconds before I can continue (Is this normal?). Then I go to the General Setup and set the hostname, etc. When clicking save, this takes about 15 seconds (OK, better). Then I go to start configuring my gateways and static routes. I can get through creating the Gateways without issue. But, when I start creating static routes, I have all kinds of problems. Either after clicking Save or Apply Configuration, my web browser will time out. I won't be able to reconnect that session for 1 to 2 minutes. It will then reconnect, but the page I was working on did not save. I can usually get 1 route in at a time before this process repeatedly happens. Now, as soon as my browser is timed out, I can close the browser, re-open it and get logged in no problem. However, I can only make about 1 change before I get timed out again.
Now, back at the console. When this happens, my CPU usage in nothing. However, if I watch the filter logs, as soon as I am timed out, I see a ton of the following:
rule 2/0(match): block out on em0: 192.168.13.1.443 > 192.168.13.4.xxxxx: tcp 4 [bad hdr length xx - too short, < 20]
(The X's are random numbers)
Can anyone help out here?
Thanks,
Jeff
-
Just installed v1.2.3 from scratch and ran through my entire config without any issues… Definitely doesn't like something about 2.0.