On boot, stuck loading interface (wireless)

[wm408]

I have been testing with an atheros card and it is working good.  It handles 2 interfaces, ath0_wlan0 and ath0_wlan1 no problem.  Until I do a reboot or cold boot…

If I do a reboot, having not configured the second interface, (ath0_wlan1), and I only have the first interface (ath0_wlan0), the box boots fine.

BUT...

If I do a reboot or a cold boot, and I have both interfaces configured, ath0_wlan0 and ath0_wlan1, it looks like it hangs while trying to load the atheros's second interface, ath0_wlan1.

Here is the output on the screen on the serial port, (WWAN = ath0_wlan0, WLAN = ath0_wlan1):

Configuring WWAN interface...done.
Configuring WLAN interface...ath0_wlan0: ieee80211_new_state_locked: pending SCAN -> AUTH transition lost
ath0_wlan0: ieee80211_new_state_locked: pending SCAN -> AUTH transition lost
ath0_wlan0: ieee80211_new_state_locked: pending SCAN -> AUTH transition lost
ath0_wlan0: ieee80211_new_state_locked: pending SCAN -> AUTH transition lost

This message continues to repeat itself indefinitely, and I cannot recover, I have just been re-flashing the CF card to start over and reload the config.

Any thoughts here?