(RE)Enabling captive portal requires restart?
-
I had an active captive portal instance running and unchecked "enable captive portal" to allow everyone to pass through for a special event.
Now I want to reenable it. I have checked enable and saved and I now have the ipfw rules in the correct context but I'm never redirected to the login page. It's working as if the portal was disabled. There are no mac addresses visible in the "ipfw -x zone_name list" nor in table 1 or 2.
Is there something else I have to do short of a restart to send the traffic on this interface through ipfw again? (restarting, based on prior experience, will fix it.)
2.1 20130705-1836
Thanks.
-
Steps to reproduce:
Fresh install of tonight's 2.1-RC0
Standard WAN/LAN NAT/PAT config
Enable Captive Portal on LAN, no authentication
CP functions normally.
Edit CP Instance, Disable CP.
Traffic passes from LAN normally.
Edit CP Instance, Enable CP.
Traffic continues to pass from LAN normally, never redirecting to CP.
The only way I can get the CP to function again is to restart.
Tried deleting and recreating CP, no change until restart.
-
Is this the way it's supposed to be?
