What does it show when you go into the OpenVPN status page? I would start by checking your OpenVPN log to see if there is a problem. You may want to post some screen shots of the settings you used to configure your openvpn client and the  ovpn file itself.

HI Both,  Excellent thanks that worked. Much appreciated.

Is this happening on your phone when you are connected to your VPN from the outside? If so you could have the option to force traffic through the tunnel and are missing the allow rule on your OpenVPN interface. Can you post a screenshot of your interfaces tab and of your OpenVPN config?

You need a route on the client settings to the server side subnet and the iroute on the connecting client to the server side subnet in order for the Clint subnet to respond to packets from the server side subnet. Example If your server side subnet is 10.2.0.0/24 you need to add iroute 10.2.0.0/24 to the client specific overrides section of the OpenVPN configuration on the client side

If you open a command prompt and run a route print do you see a route to the server subnet through the tap interface IP?

Install the OpenVPN client exort utility package. After you get a tab for the export utility in VPN > OpenVPN. Use this tool to export the certs and config and check "Password Protect Certificate".

Yeah outbound NAT on LAN

I finally found the problem. My ANTI VIRUS was blocking connection, so i had to edit the AV rules.Thanks to you all!!!!

So you have your sites connected to a mpls cloud.  And these sites also have internet where you run a vpn tunnel between the locations. Now you want to auto use the vpn connection over the internet if the mpls is down? As helper stated this is normally done via running a routing protocol.. If the mpls goes away that route drops off and you use the less priority route.

well i just ended up reinstalling pfSense again from scratch  and its working the OpenVPN its just odd this happened Thanks again

I found a workaround of sorts: unchecked the "bridge dhcp" box left "bridge interface" set to none left "server bridge dhcp start" and "end" blank in custom options i added: server-bridge 10.1.0.1 255.255.255.0 10.1.0.150 10.1.0.200; push "redirect-gateway def1" (it was the "server bridge" command that was setting the wrong gateway in the openvpn config.  As i wanted to keep all config in the xml, this seemed like the easiest workaround) thanks! -bmwt

Some update here. No problem with OpenVPN Client 2.3.14 Only higher versions are affected

problem solved. decreased "time period" (Time period in milliseconds over which results are averaged. Default is 60000.) to 5000 Now wan correctly goes down, OpenVpn do not crash.

Never mind. The things I wanted to add to the config needs to be done on the client-export tab. This is resolved now.  8)