I've seen dpginger not come back up after transient packetloss. I've had this happen a few times in the past few months where my ISP would fail-over, resulting in a few seconds of pure loss in the middle of the night, only to wake up and see my quality graph showing 100% loss since that event until I restart the service. It's possible dpinger is just not recovering from loss and continues to mark the interface as offline?

At status log: /system_authservers.php: ERROR! ldap_get_user_ous() could not bind to server .

@jimp: Just /cf/conf/config.xml The RRD is a lost cause. The Soekris device could only run 32-bit, and whatever you replace it with should be 64-bit, so you can't just straight-copy the RRD files. Well crud. So much for that. If you could boot that pfSense install and do a config backup from the GUI you could include the RRD in an architecture-independent way there, to import into a new system. But either way it's not worth the extra headaches. Oh well. I guess that's better than starting from scratch. Thanks for the info, hopefully my PFsense appliance will show up early next week and I can get that going.

Those a FIN packets, indicating the TCP state should die. This is only a symptom of a problem. What this does mean is the connection is created and established. Something is going wrong when your PS4 is trying to end a connection.

I put my NAS,Server and Router in one box.They are hosted under ESXI6.5 and I pass through my disks to nas vm with a LSI-92118I card(flashed into it mode already) .

…Now to come up with a revised numbering scheme for 100+ domestic devices!

NanoBSD is no more secure or protected than the standard FreeBSD installation is. From the functional point of view they are identical. The differences are only in the way the configuration files are handled to reduce unnecessary writes on media that doesn't cope well with excessive writing such as CF cards.

@stevetingate: no i just dont want to have to rely on the software being available, That's exactly how I felt, so was really p***ed when Apple dropped PPtP on the iOS 10 upgrade, as I used that for (emergency) remote access. Luckily I got over that, as pfsense dropped it as well, just after I started testing!

Check your Interface/Firewall Rules - do you have "Block private networks" enabled?

Thanks for your help. I will investigate further on those grounds. I'll keep you filed. Thierry

Hi, i tried 16) Restart PHP-FPM and now is working. Thanks.

Did you get the batch file created successfully?

For what possible reason? So your on the LAN but your hitting your public IP to access the web gui?  Makes zero sense to me..

I asked on IRC and got an answer pretty quickly, and it worked! <piba-nl>vrelk, hardware offloading , turn it off <vectr0n>system -> advanced -> networking, if unsure of where it is :)</vectr0n></piba-nl>

Sigh. Hopeless. Bye.