@stephenw10 Thank you for your help. I changed USB port and it worked.

Check the actual partition size: gpart list

@stephenw10
282eef10-63cc-40bb-a0e0-8bdf16a380c8-image.png

@cmcdonald I was able to open a ticket and get the install media easily. I am back on 23.09.1 and have restored my previous config. Good to go now thank you for your help.

@Zwei said in [Solved] Virtualbox + PFSense + OpenVPN – No Route to Host:

"Win10 + Virtualbox + PFSense + OpenVPN – No Route to Host"

This is a really common problem and you may be the only person to have ever solved it and written a post about it.

Thank you!

If there's an external switch on the LAN side with the clients connected to that they should always be able to ping each other. If they cannot it's probably a bad subnet set somewhere. Or they aren't receiving an IP/subnet at all.

@cschumann said in Upgrade 23.09 to 23.09.1 failed:

Hello,

I get this error at the update-process:

Updating the EFI loader
install: //boot/efi/efi/boot/INS@PATnQX: Input/output error
pkg-static: POST-INSTALL script failed
failed.

What can I do?

Problem solved with this ticket:

Unable to upgrade from 2.7.1 to 2.7.2 | Unmounting /boot/efi... done. | failed.

https://forum.netgate.com/post/1140955

Hmm, disappointing. It's common to see a lot of errors at upgrade if you're looking at the console. It should still succeed of course!

@pixel24 Always read the release notes ;)

https://docs.netgate.com/pfsense/en/latest/releases/2-7-1.html#troubleshooting

@stephenw10 Steve, I will continue tomorrow with your valuble new suggestions to solve my problem and will let you know the results.
Thanks sofar, Felix

There is a ZFS widget in Plus but it doesn't specifically show mirror status. There isn't yet a gui method to add/remove disks from the mirror.

For reference it was this: https://redmine.pfsense.org/issues/14026

@stephenw10 said in pfsense 2.7.2 Never completes startup process:

No outbound NAT perhaps?

i sent pm to you.

Hmm, do you mean you were setting that in the setup wizard?

@codemonkey76

Hello, I have exactly the same model from Hystou and it ran pfsense very well .. untill I flashed an unsupported bios update ..

Would be very nice if you could get dump image out of your H3-N3160-1C and send it over to me or post anywhere on the web.

Thanks

Config rev 22.2 is the correct version for 2.6.
https://docs.netgate.com/pfsense/en/latest/releases/versions.html.

How does the restore fail?

I would install 2.7.2 and try to restore it into that directly.

I assume you did not have ACB configured?

Steve

If you install 2.7.2 clean and then restore the config file it should pull in the packages and start them with the same configuration they had.

@stephenw10

Do you by chance have any advice on this one?

'pooling' port and vLANs

For reference: https://docs.netgate.com/pfsense/en/latest/troubleshooting/multiple-disks.html#clear-the-disk

@stephenw10

Done! Thank you sir.