I have a P5LD2 SE at work. Based on the manual for that motherboard and assuming its similar enough to the P5LD2 I suggest in the BIOS main menu, IDE configuration, configure _SATA_as Standard IDE rather than AHCI and configure Onboard IDE Operate Mode as Compatible mode. I suspect (don't know for certain) that the boot code is not equipped to deal with an AHCI controller for the boot device.
Before changing anything you should record current settings so you can go back if the changes don't work.
Comparing mpd.conf and links.conf there is a line more in 1.2.1 (sometings about retry) but i try also manually inserting in shell 1.2 configuration with the log in the past posts (is one of the first thing i try and i compare…) without success.
Thank you
We have an internal IIS server which is port forwarded from the outside. With a captive portal MAC address exception it can't be accessed. Only with both "To" and "From" IP address exceptions can it be accessed.
This doesn't provide a list of the maintainers for the pfsense package. It also doesn't add the convenient links from the web interface. I'm a little confused as to why the information would go from being shown, to erased when the package is installed.
What size partition are you trying to write to? I have a 4 GB usb drive that I have successfully and I think the format type of the partition fat32 and it is able write to it from the command prompt.
It worked well. I have done it serveral times. I pull my usb drive and check the format in the AM. I will post the type and format.
RC
As shown above in the fdisk output.. its a 1GB partition. I have no problems mounting and writing to it manually. The option 98 does not mount and write the config file.
Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.
