Each VLAN will be an interface, and the current stable version only supports traffic shaping between two interfaces.

@dothoe: I downloaded, and burned pfSense-1.2.2-LiveCD-Installer.iso. I put it in the computer I plan to use as my firewall. According to all the docs I can find here I'm supposed to select option 99. The trouble is that I only get 7 options which are: 1. Boot pfSense [default] 2. Boot pfSense with ACPI disabled 3. Boot pfSense in Safe Mode 4. Boot pfSense in single user mode 5. Boot pfSense with verbose logging 6. Boot pfSense to loader prompt 7. Reboot How do I do an install? Did I get the wrong ISO? Thanks, That menu is essentially the options for the boot loader. Like options for safe mode with windows, or options for single user mode for Linux using grub or lilo. Just let it boot normally and you will see the options after a successful start-up.

@macsta: thanks wallabybob for the response. I've decided to do a full-install on my flash device, and change the setting "pfSense" to "embedded" and it has detected the USB wifi dongles fine. Now onto stability testing on the VIA chipset. Cheers you mean when it asks you which kernal to install?? im currently having the same issue and don't want to install a hard drive.  its nice and quite without one.  i assume you turn off the swap and disable logging as well to minimize the writes?

Nevermind, idiot here.  Came home, plugged it all togther properly, disabled dhcp on linksys, enabled it on pfSense and I'm srfin from home ;) Thanks again all -Marty

Today I remotely upgraded our primary firewall to 1.2.2.  It didn't came up anymore.  I went to the datacenter and it was just hanging in the boot sequence.  I have taken some information and will verify this tomorrow with the vendor.  As the bios version is the latest. So it is definitely a problem with freebsd 7.x and supermicro hardware.

Thanks everyone I'm using pfSense-1.2.3–20090718-2234-nanobsd.img.  Would I be right in thinking this version will default to vr0 and vr1?  I have tried connecting to each of the 3 ethernet ports and it appears DHCP is not active as I get no IP address. Elliot

ahh sorry i mixed up the story :P WAN was 62 lan was 192.168 numbers sorry to mislead you. the poblemen was the NIC i had an other old one. and now everything works ;)

We had the same problem. Changed to Intel NICs and it has been running for 6 months now. Check your hardware.

Well I've tried different NICs, problem is still there. Tried to install pfsense using the same CD on P45 mobo,works fine, tried installing Freenas on the same PC that didn't work with pfsense, Freenas installs just fine. I guess Pfsense doesn't support this mobo..

I can also confirm the patch works. No more kernel panic when rebuilding/degraded RAID. Tested with 1.2.3-20090623. Thank you, jimp! :)

@jahonix: You seem to have an IP conflict. Your Linksys router AND your pfSense both have the IP 192.168.1.1 - which doesn't work. Using a switch seems to be the easiest to solve this. Don't connect the router at all. Okay, seems to be a simple solution. What I figured, thank you. I'm going to be needing wireless however. But i'll cross that bridge when I get there. I think it's just a matter of adding a new interface and plugging in the router, I'll research more. Thank you  :)