Also, do NOT burn the GZ.

That wasn't the full crash dump, it didn't have any of the information from inside the textdump archive.

Bootcamp used to support BIOS/MBR only operating systems but as far as I know Apple took that away because of the messy hybrid MBR/GPT partition table system and they now require that the OS installed with bootcamp supports GPT/EFI installations.

Yeah. Now that i've installed it, no problems at all. Thanks guys.

What sort of system are you on? NanoBSD? Full install? What architecture? Are /var and /tmp in a RAM disk?

ZFS supports TRIM natively so it'll do that automatically. There is a knob to disable it if your disk blows up with it on: https://www.freebsd.org/doc/faq/all-about-zfs.html#idp59422952

Yes.

Thanks for the info.  I'll try a live linux distro of some sort and see if I can get the card to respond.

I don't know what happened to you, but I can verify that it worked with 2.3.2-RELEASE. Regards Nagilum

@kpa: As far as I know the boot loader serial port parameters have always been customizable via a /boot.config file. Has this really changed recently? In NanoBSD since 2.3, this file resets to defaults every time you reboot, and it has been told us in these forums that this is by design like so. i had to switch to full install on embedded hardware because of this.

Thanks for the quick response. What mSata SSD/flash should I get ? What do you guys recommend ?

Thank you!! That was exactly what I was looking for! I was Googling around and never found that (didn't think to try 'serial console') Thanks again!!!

nevermind it's a base64 encode

What is the IP address, netmask, and gateway being assigned by DHCP? What are the IP addresses you are trying to assign to IP Alias VIPs? PM them if you want.