Hard to say what might have happened. Might need to see a copy of the config from after configuring the VLANs and before rebooting, if there is any way to get it.

@hassankazmi: If i give static IP on client side i remain unable to access internet services. Not a DHCP issue then, unless you have the DHCP server set to only allow certain clients in an 'allow' list.

I decided to just try a fresh install.  Thanks anyways.

Also might be interesting to see if there are errors on the NIC stats.

this appears using a draytek in half bridge mode, but this way will work….... On Pfsense 2.0 it shows the assigned isp gateway that is on a diferent subnet then it doesnt work........ How to put pfsense 2.0 behaving like 1.2.3 i.e show up ""link!" instead of the isp gateway not on the subnet making everything fail.. Regards

Actually, this is hilarious! Thank you very much for the squid advice as well. I'll look into it!

OpenVPN does a keep-alive on its own, IPsec does keep-alive if you fill in an IP of the remote LAN in the keep-alive box on the tunnel config.

If you're bridging 2 interfaces then you must use the same IP range on all interfaces. Can you clarify what you're pinging from where?

Just about all CF cards created in the last few years have wear leveling.  You'll be fine with that card and the 4GB NanoBSD image.

Using beta 2. Dosen't seem to have the problem…  yet :)

@XIII: I thought that was on the roadmap? is it just that it has not yet been implemented? Per-page permissions are there, but not "read only users" that can look but not touch. There's no code around for that that I'm aware of.

pfSense isn't linux, its FreeBSD.  OSX isn't linux either.  Its based, loosely, around the FreeBSD core.

well actually i got it from you wagonza. i searched for missing gateway and came across that

Also, what sshclient are you using ? I have noticed trouble with some clients sending unwanted characters when working on older unix-systems.

@jimp: Have you rebooted since that change? Some processes will only pick up a TZ change after a reboot. Hmm.  Probably not.  I'll give that a shot.

Hi and thanks for the feedback. @eirikz: What version of Vmware is this ? ESX ? Server ? Workstation ? I'm using the vmware player. @eirikz: Also, you are on a totally different subnet, so no wonder you cannot reach the pfsense.. I'm aware of that. I was expecting that windows would take care of the network addresses in this virtual lan. Even so, I tried setting up the lan address in both subnets (192.168.30.2 and 192.168.229.2) without success. Do you have any check list or troubleshooting guide for this kind of issues? thanks again for the help