@chudak SG-4100. Working fine. Came with 24.03 and upgraded to 24.11.

Reconecting the WAN Port solves the problem.
I verified this on a Netgate 6100 and a Netgate 2100.

Yes, the 7100 can run the current release, 24.11. And it should always see Plus available.

From such an old version I would recommend re-installing 24.11 clean if you can.

Steve

Aha, that would do it. Nice. 👍

@ppal

I did the same thing on QTS to kick the tires on pfSense and TrueNAS. I am trying to recall if I used the ISO or USB passthrough to install from a USB flash drive. Regardless, I installed from scratch vs using a pre-built VM, which may not have even been available at the time. I ultimately bare metal installed TrueNAS on my QNAP appliances.

Hmm, that's a good question. Let me run some tests....

You can install using the legacy installer and upgrade if needed:
https://atxfiles.netgate.com/mirror/downloads/

Steve

Problem solved. Thank you!

@stephenw10 the net installer boots from USB, but installations don’t boot. If I use pure MBR it gets to the old F1/F2/F6 prompt but won’t go further.

@stephenw10 Both 24.03 and 24.11 are the same it after the rollback:

2.5 Gb physical interfaces on pfsense: only auto negotiates to 10/100Mb full duplex with TAP
1 Gb physical interfaces pfsense: auto negotiates to 1000Mb full duplex with TAP

At this point, I am just a bit puzzled what changed I might have done. The TAP has been in use since like late 2021 and until like a month ago everything was working at gigabit on the same 2.5Gb physical ports on the pfsense.

@patient0 I do nightly incremental backups, and full backups every 2 weeks. I keep several full generations.

The desktop data stripe is 8 x 1TB Samsung 860 SATA-3 SSDs. Boot drive is 2TB NVMe.

The NAS uses 8 x WD 14TB HDDs, again, in RAID-Z2, so there is 84TB usable capacity..

The backups tasks use Acronis True Image with a WOL script to wake up the NAS, since I don't keep on 24/7 - 8 platters are loud and use a fair amount of power. The LAN is 10 gig so even a full desktop backup isn't too long.

Hmm, yeah so far I failed to replicate that but we are digging. I've no idea how it could ever show a cost like that....

It could be for some time after an upgrade while it rebuilds the cert database. Especially if you have a bunch of packages installed.

It should finish doing that and drop back down to similar levels after that though. The dashboard consumes more CPU cycles in 24.11 because of the updated widget behaviour. That can be reverted if necessary.

Go to System > Boot Environments and remove old BEs.

Yes that error could be handled better. The 1100 hits it more than most because of the relatively low powered CPU. If you come from the dashboard to the update page the check may still be running in the background. But just refreshing the page should show it available as you found.

No, I do not have it activated. The image shows the CPU usage when the dashboard is not on screen. The high CPU usage is only when the dashboard is on screen.

That is the error I'd expect when trying to authorise against radius but I'd expect some other code when trying to start the service If it fails to start.

Just updated my NDI after adjusting NICs, and the above issue has been resolved automatically.

@terryzb
I ignored the "Another instance of pfSense-upgrade is running." message and with 24.11 selected, ran option 13 again and this time it upgraded.

Other than the CPU ranging between 70-100% and the GUI being very sluggish, it seems to be working.